OUTLOOK EXPRESS INSTRUCTIONS

Configuration of NConnect Internet email accounts in Outlook Express

1.  Open Outlook Express and then click on Tools, and then Accounts.

2.  Select the Mail tab by clicking on it. Then highlight mail.nconnect.net mail account you need to modify by clicking on it and then click on Properties.

 

Internet Accounts

 

3.   Configure the General tab to fit your specific information. Set the Name to match yours and add your Full Email address. When finished click Apply.

 

General Tab with in Accounts

 

4.  Click on the Servers Tab. Setup the fields as shown by entering pop.nconnect.net in the Incoming (pop3) area and the smtp.nconnect.net in the Outgoing mail(SMTP) area as in the picture below. Enter your email address in the Account Name field, and enter the password you created  in the webmail setup into the password field. Do Not check Log on Secure Password Authentication.  Click My Server Requires Authentication. Then click on Settings, and verify that Use same settings as my incoming mail server is checked, click OK and OK again, and then click Close.

Servers Tab within Account Settings

Outgoing Mail Server Within Accounts Tab

5.  Click OK and Close and you are finished.

 

Web Mail access away from home, type in a blank address bar: mail.bertramwireless.com and enter your full email address and password. Or go to the web site www.bertramwireless.com and use the blue webmail button on the left side of the screen.